Tork Craft | Annular Hole Cutter HSS 44 X 30mm Broach Slugger Bit Festool_Domino Sand carefully before application starting

Sand carefully before application starting with a coarse paper – final sanding for flooring should be with a P120 – P150 grit paper

This the ¾" roughing gouge is probably the most popular

Sharp teeth for greater material removal

DEEP CLEANING

Tork Craft | Annular Hole Cutter HSS 44 X 30mm Broach Slugger Bit Festool_Domino Sand carefully before application startingAnnular Hole Cutter HSS 14 X 30mm Broach Slugger Bit One way to avoid dimpling and deburring while making holes in tube and pipe is to use annular cutters. Because annular cutters are hollow on the inside, there is no dead zone resistance to overcome. Using a twist drill to make holes in pipe or tubing can prompt concerns about the hole roundness, location accuracy, hole finish, chip extraction, burrs, and drilling duration. The focal point of these